KD Scientific Adagio Control Software for Legato Series Manual User Manual
Page 9
Adagio User Manual
© 2010 KD Scientific
5619-001 Rev B
9
Before using the rest of the application functionalities, Adagio must
establish communication with any pumps that will be controlled by the
software.
To open the Pump Configuration window, click on the Configure
Pumps button located at the top of the screen.
When the Pump Configuration window is first launched Adagio will
automatically check for connected pumps. If a pump is detected the
Pump Configuration Assistant will launch. (see section 3.1.3)
The rest of the menu options (Define Methods and Execute
Methods), will be disabled while the Pump Configuration window is
active.
The Pump Configuration window shows the list of defined pumps to be
considered within the rest of the application’s options (such as Method
creation and execution).
Each defined pump is represented by a row in a table with the following
information:
• Status: shows an icon representing the connectivity of the pump :
o
Green
: Ready. The pump is correctly defined and connected
to the computer.
o
Gray
: Off-line. The pump was correctly defined but it is not
currently connected to the computer.
o
Red
:
Wrong. The pump model currently connected to the
computer does not match with the defined pump.