Landoll 9630 Field Cultivator - Manual (Page 89)

ASSEMBLY INSTRUCTIONS
3-11
Figure 3-7: LED Light and SMV Harness Wire Designations (After August, 2013)
LED Light and SMV Bracket
Installation (After August, 2013)
NOTE
For placement of light brackets, see Figure 2-1.
1. Attach left and right light bracket assemblies with
reflectors to center frame using u-bolts and hex lock
nuts (See Figure 3-6.) The yellow reflectors will face
forward on the machine. Note that the ag amber
single LED lamps are already assembled in the
brackets.
2. Attach left tail light mount to frame assembly using
u-bolt and 5/8-11 hex lock nuts.
3. Attach ag flasher control module to the right tail light
mount using 1/4-20 x 1-1/2 hex head cap screws and
hex lock nuts. Attach right tail light assembly to frame
assembly using u-bolt and 5/8-11 hex lock nuts. Be
sure that the control module is set so that the 6 pin
connector faces the front side of the machine.
4. Attach the ag red single LED lamps to tail light
mounts and reflector assembly using 1/4-20 x 1-1/2
hex head cap screws and hex lock nuts.
IMPORTANT
Make sure lights are positioned for maximum
visibility from the rear.
5. Install the rear warning light harness to the frame.
Connect 2 pin and 3 pin ends to each of the warning
lights. Connect 6 pin to the ag flasher control module.
See Figure 3-7 for LED harness wire
designations.
6. Attach front warning harness to frame. Connect 4 pin
end to the ag flasher control module.
7. Insure that the harnesses are clear of any moving
parts and secure the harnesses with tie wraps
provided.
8. Install the stor-away holder to hose holder on hitch
with 1/4-20 x 1 hex head cap screws and hex lock
nuts.
9. Attach SMV emblem and mounting bracket to rear
center frame bar using u-bolt, 1/4-20 x 1 hex head
cap screws, and hex lock nuts. The SMV sign should
be centered on the back bar of the frame.
7-PIN
CONN
1
2
3
4
5
6
7
D
B
A
C
GROUND
WORK LAMPS
LEFT FLASHING
& TURN
STOP LAMPS
RIGHT FLASHING
& TURN
TAIL LAMPS
SWITCHED
POWER (12V)
4-PIN
TOWER
GROUND
BLACK
YELLOW
RED
GREEN
BROWN
BLUE
CIRCUIT WIRE
COLOR
m176603 wire designations op
WIRE DESIGNATIONS FOR MAIN HARNESS WIRE DESIGNATIONS FOR REAR HARNESS
A
B
C
D
E
F
2-PIN
TOWER
3-PIN
TOWER
6-PIN
SHROUD
3-PIN
TOWER
2-PIN
TOWER
A
B
A
B
C
C
A
B
A
B
A B C D E