Lenze EPM-H515 - Manual (Page 52)

Preface and general information
About these Operating Instructions
1

52 EDBPM-H515 DE/EN/FR 2.0
1 Preface and general information
This EPM-H515 operating unit enables you to access codes of Lenze controllers and
to control them easily. Communication takes places via the system bus (CAN).
The »HMI Designer« Lenze software allows for easy programming of the operating
unit.
1.1 About these Operating Instructions
ƒ These Operating Instructions describe safe and trouble-free working on and
with the EPM-H515 operating unit.
ƒ All persons working on and with the EPM-H515 operating unit must have
these Operating Instructions available and observe all relevant information
and notes.
ƒ These Operating Instructions must always be kept as a complete document
and in a readable state.
1.2 Terminology used
Term Used in this text for
Drive controller Lenze frequency inverter 8200 vector and 9300 vector, servo inverter
9300 and 9400
HMI Human Machine Interface
1.3 Scope of supply
Quantity Important
1 EPM-H515 operating unit After receipt of the delivery, check immediately whether
th it d li d t h th i
5 5 ope at g u t
1 Operating Instructions
6 mounting clamps
te ece pt o t e de e y, c ec ed ate y et e
the items delivered match the accompanying papers.
Lenze does not accept any liability for deficiencies 6 mounting clamps
6 screws M4 × 35 mm
Lenze does not accept any liability for deficiencies
claimed subsequently.
6 screws M4 × 35 mm
1 seal
claimed subsequently.
Claim
visible transport damage immediately to the
1 seal
1 4-pole terminal strip for connection of DC
voltage supply
visible transport damage immediately to the
forwarder. voltage supply
1 5-pole terminal strip for system bus (CAN)
forwarder.
visible deficiencies/incompleteness immediately to
i
1 5-pole terminal strip for system bus (CAN)
connection
visible deficiencies/incompleteness immediately to
your Lenze representative.