MBT Lighting LZ500 - Manual (Page 4)

4
1. Mode settings: Based on different application, different modes are set. If in DMX mode, bear in
mind the correct DMX address assignment.
2. Connection: connect the projector and DMX 512 console with the DMX signal cable. As for Stand
Alone, there is no need.
3. Powered on, laser emits the beam in 2 seconds.
4. The projector can be controlled to play and edit shows by DMX512 console in DMX mode, by
default program in auto mode, and in sound active mode if sound sensitivity knob is kept in proper
position
M/S mode:
1. Stand Alone——Via MASTER_ SOUND or MASTER_ AUTO, no console is needed. Laser shows
only obey sound or default program.
2. Mode settings: set the dipswitch in corresponding position, that is
MASTER_ SOUND：＃10－0，＃11－0, ＃12－0
MASTER_ AUTO： ＃10－0，＃11－0, ＃12－1
SLAVE: ＃10－0，＃11－1，＃12－1
3. Connection: Use XLR- XLR cable to connect the Master’s DMX output with the DMX Input of the
first Slave, and then output of the first Slave with input of second Slave till all the Slaves are
connected in this way.
4. Powered on, laser emits the beam in 2 seconds
5.The projector can be controlled to play shows by default program in Auto mode, and in MASTER_
SOUND mode if sound sensitivity knob is kept in proper position
Note:
1. Via Master/Slave mode, there should be only one Master and no DMX512 controller.
2. Power on the Master and the Slaves at the same time or first power on the Slaves, then the
Master.
N. SLAVE 2.SLAVE 1. MASTER( Sound/Auto )
MASTER /SLAVE Connection
DMX Mode:
1. Use standard DMX512 console in DMX Mode.
2. Mode settings: set the dipswitch in corresponding position, that is DMX Mode：＃10－0，＃11－
1, ＃12－0.
3. Connection: Use XLR-XLR cable to connect DMX 512 console with the DMX Input of first
projector, and then output of the first projector with input of second projector till all the projectors
are connected in this way.