MBT Lighting LZ500 - Manual (Page 5)

5
4. Powered on, laser emits the beam in 2 seconds
5. Console control
N. DMX 2.DMX 1. DMX
DMX Connection
Accessories:
1.User Manual 1PCS
2. Handle 1PCS
3.DMXcable 1PCS
4. Power cable 1PCS
Trouble Shooting:
Problems Reasons Remedy
Power indicator off
and no laser
Check if AC power matches
specified Make sure of the specified power or
check the power facility
Via stand alone mode:
power indicator on, no
laser
Set to Slave mode by mistake
Set to Stand-alone mode
(Stand-alone Sound Active or
Stand-alone Auto)
Via M/S mode,
Slave projector works
abnormally
1. The mode setting (only one
Master with others set as
Slave)
2. Check if there is DMX console
or not
3. Check the connection between
Master and Slaves
1.Set the work mode properly
2.Disconnect with the DMX signal
3.Make sure of the connection
between Master and Slaves
Via DMX mode, DMX
indicator off and no
laser
1. Check if the work mode is set
to DMX mode .
2. Check the XLR-XLR cable’s
connection and quality
3. Set the work mode to DMX
mode properly
4. Make sure of the XLR-XLR
cable’s connection and quality
Via DMX mode, DMX
indicator flicker,
but out of control of the
console. Make sure the DMX console’s
channel distribution match with the
laser’s Set the console’s channel
distribution and the laser’s DMX
address again.
Some patterns are
blocked
—————
Power on again and the system
regain normality