MBT Lighting CX1616 - Manual (Page 5)

Repeat steps 3 and 4 until you have programmed all your
desired step for your new program. You may program up
to 100 steps per a program pattern chase.
Step 6:
When you have completed your programming press the
Blackout Button to exit program mode.
Fade Intensity (quick start) : Note this function allows you to program
static scenes or chase patterns with varying light level intensities. These
programs may be stored into any of the 16 user Pattern Buttons. This
programming procedure may also be combined with the “Fade channel(quick
start)” programming instructions.
Step 1:
Press the Program Manual Buttons until their green
indicator LEDs light up. Please note: If the program LED
indicator does not light up, the controller is in Lock
Mode. To unlock the controller please see “Lock Function”
in this manual.
Step 2:
Select a pattern bank (Program Buttons 1-16) you wish to
store your program to. Press the Pattern Button and its LED
will begin flashing slowly indicating program mode has been
activated.
Step 3:
Use the slider to adjust your desired channel intensity. The
channels intensity will vary depending on the position of the
slider. When the slider is set to zero (0) there will be no
channel activity will be at it’s maximum. The LCD display
will also detail the channel fader level in increments of zero
to 100.
Step 4:
After you have set all your desired channel fader level, for
a scene or chase step, press the Program Button to lock
this scene into the controllers memory.
Step 5:
Repeat steps three and four until you reach a 100 steps or until
you have programmed all your desired step.
Step 6:
When you have completed all your steps for this program
press the Blackout Button to exit this function and
automatically end the program function.
 Programming with Audio Effect