MK Diamond MK-377 - Manual (Page 18)

18
WATER PUMP PREPARATION
(B)
Connect the Cooling Transfer
Tube to the inlet connection of
the Blade Guard
(A)
Press the end of the Cooling
Transfer Tube onto the Water
Pump
(E)
Verify the Movable Cutting
Table moves freely
(D)
Inspect the MK-377 for
damage – ensure the cord is
free of cracks or cuts
(D)
Fill the Water Pan with clean
water covering Pump suction
(this should be done periodically
during cutting)
(E)
Connect the Water Pump power
cord to the connection found on
the back of the motor
MK-377 SAW ASSEMBLY
(C)
Place the Water Pump in the
Water Pan with the suction down
and insert the Pump Cord to the
clip in the back. Ensure pump is
against back of water pan.