Mk-377 saw maintenance – MK Diamond MK-377 User Manual
Page 22
22
(K)
Lubricate the Roller teel
Assembly
(J)
Lubricate the Guide Bar
To extend the life of th MK-377, the following procedure should be performed after
each use. Lubricate all points listed below with light oils such as, 3 in 1, WD-40, etc.
CAUTION
LOCKOUT
The MK-377 is equipped with a lockout device that can be used during maintenance and troubleshooting
to render the saw in operable. The lockout can also be used to prevent unauthorized use.
(A)
Locate the Lockout Pin in the
center of the ON/OFF Switch
toggle (the Lockout Pin has
"Remove To Lock" highlighted)
(B)
Lockout the Saw by removing
the Lockout Pin
MAINTENANCE
Monthly Maintenance
The following maintenance should be performed monthly.
(B)
Clean the Motor Shaft
(A)
Remove and clean the Inner and
Outer Flanges and the Blade
Retaining Nut
(C)
Lubricate the Motor Shaft
MK-377 SAW MAINTENANCE