MK Diamond MK-377 - Manual (Page 21)

21
(D)
Fill the Water Pan with
clean water
(B)
Dispose of the contents of
the Water Pan and clean
the pan. Replace the
Cutting Assembly.
(A)
Ensure the ON/OFF Switch is
in the OFF position. Remove
the Cutting Assembly from the
Water Pan
CLEANUP
Dispose of wastewater in accordance with applicable Federal, State and Local laws.
(C)
Clean the Water Pump of all
debris. (Refer to water pump
manual for more detail)
(E)
Run the MK-377 until clear
water is seen at the blade
cooling ports (Approx. 1
minute)
Ensure the saw is disconnected before completing the remainder of the
cleanup process.
CAUTION
NOTE:
MK-377 SAW MAINTENANCE
(F)
Dispose of the contents of
the Water Pan and clean the
MK-377 with soap and clear
water
(G)
Clean the Guide Bar
(H)
Clean the Roller Wheel
Guide Rail
(I)
Clean the Roller Wheels
CAUTION To extend the life of the MK377, lubricate the Motor Shaft with light oils such
as, 3 in 1, WD-40, etc.