MK Diamond MK-101 JCS Rental - Manual (Page 10)

MK-101 Home Depot Rental Revision 04/05, Effective Date April 21, 2005 Page 10
SAFETY
PRODUCT SPECIFICATIONS:
The MK-101 is a versatile Tile Saw. Operated and used according to this manual, the MK-101 will provide
years of dependable service.
General Description:
The MK-101 Tile Saw is engineered as a tabletop or stand mounted wet tile saw. The saw includes a powerful 115v
totally enclosed capacitor start Baldor motor with a thermal protective overload. The saw is capable of cutting tile up to
twenty (20) inches in length, or diagonal cutting tile up to fourteen (14) inches. The saw can cut an object three and one-
half (3-1/2) inches thick in one pass.
Motor Specifications:
Motor specifications for the MK-101 are listed in Table 2 below.
Voltage 115 v
Overall Amperage 13 a
Motor Only Amperage 12.4 a
Frequency 60 Hz
RPM 3450 rpm
Horse Power 1.5 hp
Weight 128 lbs
Table 2
Thermal Overload Protection:
The motor is protected by a thermal overload equipped with a manual reset.
Blade Capacity:
The MK-101 uses a ten (10) inch (254mm) diameter, wet cutting continuous rim, MK Diamond blade with a one-
sixteenth 1/16 inch (1.5875 mm) cutting width and a five-eighths (5/8) inch (15.875 mm) arbor.
Tile Types:
The MK-101 can cut a variety of tile types including Porcelain, Terracotta, Marble, Quarry and Slate, or almost any
other non-ferrous material.
NOTE:
The MK-101 is not designed to cut plastic or ferrous (metals) material.
The following warnings are for the MK-101 w/JCS Stand
Read and understand all instructions
Maximum material load 35 lbs. (15.9kg)
Place unit on a hard level surface.
DO NOT use as ladder or scaffolding.
Always use with Safety Arm in place (see SET UP section on pg. 12)