MK Diamond MK-101 JCS Rental - Manual (Page 16)

MK-101 Home Depot Rental Revision 04/05, Effective Date April 21, 2005 Page 16
UNPACKING, TRANSPORT, JCS STAND and ASSEMBLY
ASSEMBLY:
Follow the assembly instructions to prepare your MK-101 for operation.
1. Cutting Head Installation:
2. Diamond Blade Installation:
NOTE: When installing the Retaining Screw, do not “cross-thread" and DO NOT over tighten the screw.
(A)
Position Movable Cutting Table
to the front of the saw and
raise the Blade Guard
(C)
Depress and hold the Shaft Lock
pushbutton and remove Retaining
Screw and Outer Flange using
the Blade Wrench
(D)
Install Diamond Blade
onto Blade Shaft
(E)
Verify the Blade is seated on
the Blade Shaft and direction
of rotation is correct
(F)
Install Retaining Nut and Outer
Flange, depress and hold the
Shaft Lock pushbutton
and Tighten
Pivot Blade
Guard up Tighten
Wing-nut
Movable
Cutting Table
Turn counter-
clockwise to
loosen
Press and
Hold
Retaining Screw
and Outer Flange
Diamond
Blade
Rotation Direction
Rear Pivot
Hole
Rotate Blade
Wrench clockwise
to tighten
(B)
Locate the Shaft Lock pushbutton
on the underside
of the Cutting Head
Cutting
Head
Shaft Lock
Pushbutton
Blade
Wrench
Blade
Shaft
(A)
Locate Rear Pivot Hole
on Cutting Head
(C)
Install the Adjusting Knob
(B)
Align and insert cutting head onto
pivot pin