MK Diamond MK-101 JCS Rental - Manual (Page 17)

MK-101 Home Depot Rental Revision 04/05, Effective Date April 21, 2005 Page 17
UNPACKING, TRANSPORT, JCS STAND and ASSEMBLY
3. Adjustable Cutting Guide Installation:
NOTE: The Adjustable Cutting Guide can be used on either side of the Diamond Blade.
4. Splash Guard Installation:
5. Water Pump Preparation: :
(A)
Loosen Adjustable Cutting
Guide retaining thumbscrew
and place it over the Movable
Cutting Table Ruler/Stop
(B)
Place the Adjustable Cutting
Guide onto the Movable Cutting
Table Ruler/Stop and tighten
the retaining thumbscrew
(A)
Install Water Pump
Discharge Fitting
(A)
Install the retaining thumbscrew
through the washer and Splash
Guard then align to the hole found on
back of the Blade Guard
(B)
Install the Splash Guard
onto the Blade Guard
Turn counter-
clockwise to loosen
Ruler/Stop
Adjustable
Cutting Guide
Turn clockwise
to tighten
Ruler/Stop
Adjustable
Cutting Guide
Thumbscrew
Splash
Guard
Cooling
Transfer
Tube
Turn clockwise
To tighten
(B)
Press one end of the Cooling
Transfer Tube onto the Water Pump
Discharge Fitting
Turn clockwise
to tighten
(C)
Slide Cooling Flow Adjusting
Clamp onto the Cooling
Transfer Tube
Discharge
Fitting Press on
Flow Adjusting
Clamp
Press on