MK Diamond TX-3 - Manual (Page 13)

13
Misting Version Only, Part #164800
Flood Version Only, Part #166634
The TX-3 is a versatile tile saw. Operated and used according to this manual, the TX-3 will provide years of
dependable service.
TX-3 PRODUCT SPECIFICATIONS
PRODUCT SPECIFICATIONS
GENERAL DESCRIPTION
VOLTAGE 120V
AMPERAGE 15
FREQUENCY 50-60 Hz
RPM 3,500 RPM
WEIGHT 85 lbs. (39 kg)
PART # DESCRIPTION
164800 With Misting System
166634 With Flood System
The TX-3 is engineered as a 10” Tile Saw with a misting or flood system.
MOTOR AND WEIGHT SPECIFICATIONS
Motor and Weight specifications for the TX-3 are listed in the Table below.
BLADE CAPACITY
The TX-3 uses a 10-inch diameter segmented MK Diamond blade with a .06-inch cutting width and 1-inch
arbor.
TILE TYPES
The TX-3 can cut a variety of tile types including stone, masonry, and lapidary products.
NOTE
The TX-3 is not designed to cut plastic or metals.
SPRING ASSISTED CUTTING HEAD
The TX-3 is designed with a spring assisted Cutting Head to allow for plunge cutting. The Cutting Head can be
locked in any down position when using with smaller blade or profile wheel.
REMOVABLE MOTOR AIR FILTER
The TX-3 is designed with an easy clean motor air filter to extend the life of the motor.
REPLACEABLE MOTOR BRUSHES
The TX-3 is designed with replaceable motor brushes to extend operating life.