MK Diamond TX-3 - Manual (Page 16)

16
TX-3 INSPECTION & START-UP
5.
6.
Turn 45º Adjustment Screw (G) and set vertical position of Roller Wheel Bracket (I) until Blade is parallel
with 45º level on the Combination Square (H).
Tighten Hex Nut on the 45º Adjustment Screw (G) to secure Screw and Roller Wheel Bracket (I) in place.
Fig. 16 Remove material slide
45º MITER ADJUSTMENT
A Combination Square (H) is needed for 45º adjustment.
1.
2.
3.
4.
Loosen Miter Adjustment Knob (C) and tilt Cutting Head.
Remove Outer Blade Guard by turning Outer Blade Guard Release Knob (D) and pushing Outer Blade
Guard back.
Remove Misting Module (E) by loosening the two Misting Module Screws (F).
Loosen the Hex Nut on the 45º Adjustment Screw (G).
E
G
C
D
F
H
I