MK Diamond TX-3 - Manual (Page 15)

15
1.
2.
BLADE ALIGNMENTS
The TX-3 has been factory aligned. If any adjustment should occur, refer to steps below for specific adjustments.
Loosen Hex Nut (A) on blade depth adjustment screw.
Set Blade (B) approximately 3/16” below the table surface by turning adjustment screw. Retighten Hex Nut
to secure Screw after desired depth is achieved.
TX-3 INSPECTION & START-UP
SETUP AND ADJUSTMENTS
WARNING
ALWAYS disconnect unit from power supply when performing changes or adjustments.
You will need the following tools:
1.
2.
3.
A
BLADE DEPTH ADJUSTMENT
Combination Square
Hex Nut Wrench Set
Phillips Screwdriver
B