MK Diamond MKDX Profile Milling Machine - Manual (Page 28)

28
MKDX MAINTENANCE
CLEANING THE MACHINE
DANGER
Before performing any operation, make sure that the machine is unplugged.
Fig. 43 Open water tank door and remove plug
1. Open the water tank door. Remove the plug to empty the water (Figure 43).
2. Remove filter and clean off tile chip debris. (Figure 44). Check tank for other chips and debris,
remove all.
3. Replace filter and plug.
• Keep the material slide guide clean. Never use blasts of water, instead use a damp sponge.
• Lubricate the vertical adjustment guide.
CLEANING THE TANK & FILTER
Fig. 44 Remove filter and clean off tile chip debris
ADJUSTING THE SLIDING DEVICE
1.
2.
If you notice that the material slide guides have excessive clearance, the material slide has 8
screws that may need to be adjusted (Figure 45).
Loosen the screws. Move the guides closer to the wear bar to take up the clearance. Tighten the
screws after adjustment (Figure 46).
Fig. 45 Adjust material slide screws Fig. 46 Move guides closer to wear bar
GUIDE
GUIDE