MK Diamond MKDX Profile Milling Machine User Manual
Page 8
8
•
MKDX
SAFETY
• ALWAYS
disconnect AC power plug from power source before moving or servicing the machine.
•
Make sure the OFF/ON power switch on the electric motor is always in the OFF position before
inserting the machine’s power plug into an AC receptacle.
•
Operate electric motor only at the specified voltage indicated on the nameplate.
• NEVER
disconnect any “emergency or safety devices”. These devices are intended for operator
safety. Disconnection of these devices can cause severe injury, bodily harm or even death! Dis
connection of any of these devices will void all warranties.
•
Unauthorized equipment modifications will void all warranties. Manufacturer does not assume
responsibility for any accident due to equipment modifications.
• NEVER
use accessories or attachments, which are not recommended by MK Diamond for this
equipment. Damage to the equipment and/or injury to user may result.
The MKDX Bullnose and Shaping machine is designed to be used only with approved diamond
cutters. All bullnosing and shaping must be done with water as a coolant.
•
•
•
NEVER
lubricate components or attempt service on a running machine.
Keep the machinery in proper running condition.
Fix damage to the machine immediately and always replace broken parts, or missing decals.
MAINTENANCE SAFETY
•
WATER SAFETY
•
Before starting any type of profiling operation, always check the level of cooling water.
SHAPING SAFETY
Before starting any type of shaping operation:
MOTOR OVERLOAD SAFETY
If the machine goes off unexpectedly, the motor’s overload cutout may have been activated. In this
case, unplug the machine from the power supply and wait until the motor and overload cutout have
cooled down.
WARNING
Never use this machine with any cutter designed for wood working.
Always check that the spray guard is in place.
Always check that the profile wheel is sharp. If necessary, sharpen using a sharpening stone.
Always check that the profile wheel shows no signs of cracking. If necessary, replace it.
Always check that nobody is in the work area except those directly involved in the operations.