MK Diamond MK-EZ Profile Milling Machine - Manual (Page 19)

19
Once a tool has been installed, the fences can be adjusted for use with that particular tool.
(A)
Flip the splash guard brush up
out of the way.
(F)
Place a straight edge (at least
24" long) on the table, so that it is
touching the guide bearing on the
tool, and is approximately parallel
with the long direction of the tables.
(G)
Holding the straight edge firmly
in place, slide the left fence into
contact with the straight edge and
tighten the two bolts that hold it.
(D)
Loosen the vertical slide bolts,
raise the head so that the middle
of the lower guide bearing on the
tool is level with the table surface
and tighten the bolts.
(E)
Loosen the two bolts on both
fences and slide them towards
the back of the machine.
(H)
Now holding the straight edge in
contact with the left fence (and
guide bearing), bring the right
fence up to touch the straight
edge and tighten it in place.
(I)
The two fences should now be
parallel and the straight edge
should be able to slide from one
to the other without bumping or
catching. The profile tool can now
be set for the desired cut.
(B)
Ensure that the fine
horizontal adjustment is
approximately in the center of
its adjustment slot.
(C)
This adjustment operates by
loosening (about a quarter
turn) both of the large knobs
next to the motor, turning the
fine horizontal adjustment knob
in or out as necessary and
retightening the knobs.
MK-EZ PROFILER ASSEMBLY
FENCE ADJUSTMENT