MK Diamond MK-EZ Profile Milling Machine User Manual
Page 22
22
NOTE:
NOTE:
The best water nozzle adjustment depends on
several factors, including the material thickness and
profile tool used. The water pump receptacle cord,
that comes out of the motor, turns on and off along
with the motor. The pump can be plugged into a
receptacle or extension cord to test the aim of the
water stream, and to make adjustments without the
motor and tool running.
Most profiles can be cut in one pass. If the material
comes away from the fence while profiling, less than
the full amount of material will be removed and a
second pass will finish up the profile.
Once everything is set up, profiling is performed by sliding the material through the Profiling Tool
from Left to Right.
PROFILING
(A)
Flip the splash guard brush down
onto the table, turn on the motor and
proceed with a test cut.
MK-EZ
PROFILER
SETUP
(A)
The water nozzle can be
pivoted to provide the best
aim for delivering water to
the contact area between the
material and the tool.
WATER NOZZLE ADJUSTMENT