MK Diamond MK-1080 - Manual (Page 7)

7
MK-1080 PAVER SAW SAFETY
• NEVER stand on the tool. Serious injury could occur if a power tool is tipped, or if a cutting tool is
unintentionally contacted.
• Become familiar with the controls of the machine before operating. Know how to stop the machine
quickly in case of emergency.
• ALWAYS secure work. Clamps or a vise should be used to hold work whenever practical. Keep-
ing your hands free to operate a power tool is safer.
• ALWAYS disconnect AC power plug from power source before moving, cleaning or servicing the
machine.
• NEVER leave a tool running unattended. Do not leave a tool until it comes to a complete stop.
ALWAYS turn a power tool OFF when leaving the work area, or when a cut is finished.
• Make sure the OFF/ON power switch on the electric motor is always in the OFF position before
inserting the machine’s power plug into an AC receptacle.
• Operate electric motor only at the specified voltage indicated on the nameplate.
• NEVER disconnect any “emergency or safety devices”. These devices are intended for operator
safety. Disconnection of these devices can cause severe injury, bodily harm or even death! Dis-
connection of any of these devices will void all warranties.
• Unauthorized equipment modifications will void all warranties. Manufacturer does not assume respon-
sibility for any accident due to equipment modifications.
• NEVER use accessories or attachments, which are not recommended by MK Diamond for this
equipment. Damage to the equipment and/or injury to user may result.
• Replace damaged cutting blade before operating.
• NEVER try to stop a moving blade with your hand.
• NEVER lubricate components or attempt service on a running machine.
• Keep the machinery in proper running condition.
• Before using a power tool, check for damaged parts. A guard or any other part that is damage
should be carefully checked to determine if it would operate properly and perform its intended
function. Always check moving parts for proper alignment or binding. Check for broken parts and
mountings and all other conditions that may affect the operation of the power tool. A guard, or any
damaged part, should be properly repaired or replaced.
MAINTENANCE SAFETY
WARNING
NEVER use this machine with any cutter designed for wood working.
• Wear eye protection.
• Disconnect saw before servicing, when changing cutting blades and cleaning.
• Replace damaged cutting blade before operation.
• Remove adjusting keys and wrenches.
SAW SAFETY
WARNING