MK Diamond MK-5000 Gas - Manual (Page 35)

35
MK-5000G Block Saws - Pulley Combinations by MK Part Number
Gas Saws (9-13 Hp)
Blade Size 14 inch 20 inch 24 inch
Motor Pulley 5-7-9 Hp Elect. 9-13 Hp Gas
10 Hp Elect.
158470
•
160365
•
160365
•
Motor Pulley to Jack Shaft 160362 160362 160362
Jack Shaft to Arbor 158959 160364 160364
Arbor STD (3/4")
HD (1")
160362
161135 158959
158470 160362
161135
Motor Belts 160366
Arbor Belts 160367
(F)
Locate Cooling Channels inside
Blade Guard.
Cooling Flow stopped
(A)
Check Cooling Flow
Control Valve is open.
(B)
Remove Transfer Tube from
Blade Guard.
(C)
Place Water Pump in clean
water source and check for flow.
(if no flow go to step G)
“Rodding” cooling channels is performed by removing the flow control valve and then insert-
ing a small wire rod through the cooling channel inlet, located on the underside of the Blade
Guard. The cooling channels should be “rodded” until each of the outlet ports are open and
free of foreign debris.
NOTe:
(D)
Verify Cooling Valve operation
by removing the valve from the
Blade Guard.
(E)
Attach the Cooling Valve to the
Transfer Tube to verify flow –
if no flow, replace valve.
MK-5000G TrOUBLesHOOTiNG