MK Diamond MK-20 Series - Manual (Page 11)

11
UNPACKING
MK-20 Series
Saw
1 Blade Nut
Wrench
Engine Manual Warranty
Card
MK-20 Series
Owner’s Manual
Pointer
Handlebar
Bolts and Washers
Handlebar
MK-20 SERIES UNPACKING
03.2012
MK-20 SERIES
OWNER’S MANUAL & OPERATING INSTRUCTIONS
www.mkdiamond.com
Caution: Read all safety and operating instructions before using this equipment. This owner’s manual MUST accompany the equipment at all times.
Revision 201
Manual Part# 156777
Gas Powered
Concrete Saw
Your saw has been shipped from the factory thoroughly inspected. Only minimal assembly and
service is required. Check each item, making certain all items are accounted for and in good visual
condition before discarding any packing materials. If there are any missing or damaged parts call MK
Diamond Customer Service at 800-421-5830.
CONTENTS
In the containers, you will find one (1) MK-20 Series Saw, one (1) Blade Nut Wrench, one (1) Handle-
bar, two (2) Handlebar Bolts and Washers, one (1) Pointer, one (1) MK-20 Series Owner’s Manual,
one (1) Engine Owners Manual, one (1) Warranty Card.
WARNING Never start engine until all initial servicing and set up steps are completed accord-
ing to this operations manual and engine manual. Read and familiarize yourself
with all controls and features of the saw before beginning operations.
Remove the saw from the pallet and place it on a flat surface. Two people are required to lift saw.
MK-20 Series Series Features
• One-piece box construction chassis made from 3/16” hot-rolled steel
• Powder-coated chassis resists peeling and corrosion
• Cast-aluminum hinged blade guard
• Stainless steel water distribution system supplies water to both sides of blade
• Blade guard mounts on both left- or right-hand side of saw and cuts within 2” of wall or curb
• Heavy-duty blade shaft supported by two 1-3/16”, self-aligning pillow blockbearings
• Depth control assembly engineered for smooth, controlled blade insertion
• Built-in tach/hour meter
• Depth feed gauge indicator
• Heavy-duty hydro static transmission with variable speed drive
• Durable 8” x 2-1/4” non-slip rubber wheels with maintenance-free hubs & roller bearings
• Forward travel speed: 0-80’ minute