Mk-20 series set-up – MK Diamond MK-20 Series User Manual
Page 17
17
(D)
Check for proper oil level.
Refer to Engine Manual for details.
Low Level
Proper Oil Level
(F)
Check the Air Filter for
cleanliness. Refer to Engine Manual
for details.
MK-20 SERIES SET-UP
(E)
Ensure fuel level is 1” below the
throat of the Fuel Tank.
1 inch (25mm)
from throat
Maximum Fuel
Level
The pre-start inspection should be performed before beginning any job.
PRE-START INSPECTION
(A)
Inspect Blade for damage for
cracks and wear, replace if nec-
essary. Verify the Blade is cor-
rect for the material being cut.
(C)
Inspect the saw for general dam-
age and/or loose hardware. Check
that the equipment covers and
guards are in place and securely
fastened.
(B)
Inspect Engine for leaks.
Make sure surfaces are clean
and unobstructed.
• NEVER disconnect any “emergency or safety devices”. These devices are intended for
operator safety. Disconnection of these devices can cause severe injury, bodily harm or
even death! Disconnection of any of these devices will void all warranties.
• Unauthorized equipment modifications will void all warranties. Manufacturer does not
assume responsibility for any accident due to equipment modifications.
• NEVER use accessories or attachments, which are not recommended by MK Diamond for
this equipment. Damage to the equipment and/or injury to user may result.
WARNING