MTS Model 409.83 Temperature Controller - Manual (Page 35)

Model 409.83 Temperature Controller Maintenance 35
Maintenance
Cleaning Keep the exterior of the temperature controller free from dust and other debris.
Should the controller require cleaning, keep the following points in mind:
Do not clean the controller exterior with harsh detergents.
Use only a soft cloth to clean the exterior of the controller. If a cleaning agent is
needed, use only mild detergent with water. Harsh detergents can damage the
temperature controller finish and electronics.
• Power should be disconnected (by unplugging the AC line cord at the wall
outlet) before cleaning.
• Use a soft cloth to remove dust and other debris from the exterior of the
temperature controller. If a cleaning agent is required, use only a mild
detergent and water.
• Allow for sufficient dry time before reconnecting power to the temperature
controller.
Replacing a Eurotherm
2216
Parameters are set at MTS Systems Corporation according to the configuration
drawing (MTS part number 531124-xx). If a control module is replaced, set the
parameters according to the MTS-factory settings and then run the Eurotherm
Automatic Tuning. Once the MTS factory settings have been entered, you may
deviate from them (in small steps).
CAUTION