MTS Multipurpose Elite - Manual (Page 47)

Value Property
Time Timing Type
2 sec Time
Ramp Ramp Shape
No Compensator Compensator
Axial Channel List
Displacement Control Mode
0 mm Absolute End Level
5.2.7.0 Adding a Signal Scope Monitor
In this task, you add a Signal Scope to the test. The Signal Scope is graphical, real-time display of your test
data. When running the test, the Signal Scope simulates a conventional oscilloscope. The MPE application
requires defining at least one monitor display before you can run the test.
1. Click the Test-Run Display tab.
2. In the Toolbox panel, note the various monitor displays available.
3. From the Signal list, drag the Signal Scope icon to the Designer area. Position the display graph as desired.
4. Observe the Error icons on the Signal Scope, in the Properties panel, and in the Error list at the bottom
of the screen (you may need to expand the panel). The errors direct you to define a parameter for the Y
axis of the Signal Scope.
5. If necessary, click to expand the Traces panel. Then click the (...) icon next to the Y Signal property.
Selecting a Y Signal
6. Select Axial Displacement and click OK.
Multipurpose Elite Test Design Guide 47
5.0 Creating Tests