MTS Multipurpose Elite - Manual (Page 48)

Note:
By default, Time is the parameter used for the X axis, which is desired for the sample test.
7. In the Properties panel, expand the Y Axis panel.
8. Select the Maximum check box.
9. Set the Maximum value to 12 mm. This accommodates the amplitude of the end-level values of the Cycle
at Mean activity.
Setting the Y Axis Maximum
Signal Scope Monitor with 12 mm Y Axis Maximum
10. Click the Preview subtab inside the Test-Run Display tab to view an example of the Signal Scope monitor
display.
48 Multipurpose Elite Test Design Guide
5.0 Creating Tests