MTS Multipurpose Elite - Manual (Page 410)

Template.LCF-ElevatedTemp, Template.Trapezoidal-ElevatedTemp, Template.TMF,
Template.Transitional, Template.Transitional-ElevatedTemp.
To purchase one of these licenses and begin using this test activity, contact your MTS sales engineer.
Stable Cycle Detection Activity Properties
Stable Cycle Detection Activity Properties
Description Item
Specify the percentage of change allowable between
the Formula minimum and Formula maximum. Percent Change
Toggles between direct numeric entry and a variable
selection
Specify the number of consecutive cycles that the
Percent Change must be within its parameter in Number of Cycles
order for the command cycles to be considered
stable.
Toggles between direct numeric entry and a variable
selection
Specify the values to be compared. When the
comparison between the values is within the Percent Formula minimum
and maximum
Change for the Number of Cycles, a stable cycle is
achieved.
The Formula minimum and Formula maximum
cannot reference the same variable, and the
referenced variables must use the same unit of
measurement.
410 | MTS TestSuite
Test Activities