MTS Multipurpose Elite - Manual (Page 433)

Description Number
• DAQ List: Data Acquisition 1
• Trigger 1: Timed
• Buffer Size: 1 count
• Save data to variables: Yes, automatically map variables (signal-dependent variables)
Configure the Set Span and Setpoint activity: 5
• Maintain command: Disabled
• Monitor: Continuous
• Channel: Axial
• Control Mode: Displacement
• Span; Setpoint: Defined as calculated variable values as shown below.
• Allow activity to execute when test is stopped: Enabled
Configure the State Change Detection activity: 6
• Program state change: Stopping
Note:
If the test is stopped, the Set Span and Setpoint activities continue since the Allow
activity to execute when the test is stopped check box is enabled.
• Select the State Change Detection as a Terminal Path (see activity number 3).
Below the Parallel Paths activity, add a serial Set Span and Setpoint activity configured for
maintaining command. Property settings: 7
• Maintain command to prevent movement: Enabled
• Channel: Axial
• Control Mode: Displacement
• Span: 100%
• Setpoint: 0 (units)
• Allow activity to execute when test is stopped: Enabled
Add a Ramp activity to ramp to zero. Property settings: 8
• Timing Type: Time
MTS TestSuite | 433
Test Activities