MTS SWIFT 20 Ultra Sensor - Manual (Page 66)

SWIFT 20 Sensors 66
Edit the Calibration File
Setting up the Low-Profile Transducer Interface
Edit the Calibration File
Do not change any other items in the calibration file.
The calibration file contains offset values for all of the bridge outputs.
Changing any of the items other than those listed in the following procedure
will cause your calibration file to be incorrect.
Take care not to change any values except those listed in the following procedure.
If your calibration file is incorrectly changed, reload the original file from the
diskette provided by MTS.
What you need to
know
Before you make the changes to the Calibration file you will need to know how
your system is set up (a spinning or non-spinning configuration) and how you
want you data from each sensor formatted (the Output Polarities)
1. Open the calibration file using a text editor.
CAUTION