MTS SWIFT 10 MC Sensor - Manual (Page 29)

Transducer Interface
SWIFT 10 MC Sensors Hardware Overview 29
Transducer Interface
The TI performs cross talk compensation, transforms the loads from a rotating to
a non-rotating coordinate system, and produces an analog output signal suitable
for any data recorder.
Cross talk
compensation
Cross talk occurs when a force is applied to one axis, but a non-real force is
measured on another axis. The SWIFT sensor design has very low inherent cross
talk. The TI compensates for cross talk by subtracting cross talk values measured
during calibration.
Signal conditioning
The TI is specifically designed to be used for both spinning and non-spinning
applications. The TI performs signal conditioning and communications
functions. The output from the TI is a high-level signal suitable for input into a
multichannel data recorder or an MTS Automated Site Controller (ASC).
Fx
Fz
My
Transducer
Interface Output signals
(±10 Volts)
Angular
Position
Bridge
Output
Transducer bridge output
signals and encoder
angular position signal are
sent through slip ring
Transducer Interface
converts signals to non-
spinning vehicle coordinates,
applies calibration gains and
cross talk compensation
Force, moment, and
angle analog signals
are output from
Transducer Interface
θ Angle signal
(0–5 Volts)
S10MC-05