MTS SWIFT 10 MC Sensor - Manual (Page 85)

Road Simulator
SWIFT 10 MC Sensors Installing the Transducer 85
4. Torque the twenty M8 fasteners.
A. Following the outer bolt pattern sequence shown in the following
figure, torque the twenty M8 bolts (1 through 20) to the value for the
first increment shown in the Bolt Torque Increments table.
B. Repeat Step 5A for the final increment.
Torque Sequence
Note To minimize negative clamping effects, you must torque the bolts in the
sequence and increments shown.
5. Position the transducer, adapter, washer plate assembly against the spindle
housing.
Orient the assembly such that the Fz on the axes icon printed on the
connector side of the transducer is pointing up (see the next figure). For
future reference, mark both sides of the adapter plate to identify this
orientation.
Bolt Torque Increment
T ORQUE I NCREMENT M8 B OLT S IZE
1st Increment 19 N•m (14 lbf•ft)
Final Increment 38 N•m (28 lbf•ft)
S10MC-15
F
4
G
8
12
17
13
C A
6 1
20
15
Inner Bolt
Pattern
3
E
Outer Bolt
Pattern D B
H
10
19
16
14
18
11
7
2 5
9
Axes Icon
S10MC-22