MTS SWIFT 10 MC Sensor - Manual (Page 87)

Road Simulator
SWIFT 10 MC Sensors Installing the Transducer 87
Assembling the Non-Slip Ring/Encoder Side (typical – rear shown)
8. Assemble the slip ring/encoder side as follows (refer to the next figure
during the assembly):
A. If you have not already done so, attach the stock brake disk (if used) to
the inner hub/brake disk adapter using the fasteners provided.
Apply Locktite 262 Threadblocker to the screws and torque to the
manufacturers specifications.
B. Apply a little grease or oil to the outer surface of the axle spacer and
insert it into the inner hub adapter from the oil seal/bearing side. Push
until you feel it snap in place against the bearings.
C. From the opposite side insert the load spacer.
Apply grease to reduce
friction between axle
spacer and oil seal
and bearings
Axle
Spacer
Axle
Spacer
Inner Hub/
Sprocket or
Brake Disk Adapter
Stock Sprocket (rear)
or Brake Disk (front)
Load Spacer
Load Spacer
Inner Hub Assembly
Sprocket Side – Rear (shown)
Stock Sprocket
or Brake Disk
Oil Seal
S10MC-12R
Sealed
Bearings (2)