Setting up the transducer interface, Setting up the transducer interface 47 – MTS SWIFT 10 MC Sensor User Manual
Page 47
Advertising
SWIFT 10 MC Sensors
Setting up the Transducer Interface
47
Setting up the Transducer Interface
Overview
Two different software configurations are used by the TI, depending on whether
you will be using the SWIFT sensor on the test track (typical for spinning
application) or in the laboratory (typical for non-spinning or fixed application).
Angular transformation is required on the test track only. If you are using the
same transducer and TI for data collection on the test track and simulation testing
in the laboratory, you must change the software configuration in the TI when you
change testing modes.
Contents
Advertising