MTS SWIFT 10 MC Sensor User Manual
Page 76
SWIFT 10 MC Sensors
76
Road and Track Vehicles
Installing the Transducer
Inclinometer Mounting for Rear Wheel
6. Push the Zero button on the front of the TI box.
The Zero indicators will toggle during the zero process. When the Zero
indicators turn off the process is complete for this angle.
7. Remove the inclinometer and level bracket.
8. Repeat Step 4 through 7 three more times.
Before Step 4 of each iteration, rotate the tire 90°.
Note
If the red Fail indicator lights a problem was detected during the zero
process.Use TI2STATUS for a more detailed explanation of the problem.
Try repeating the procedure. Press the Zero button until the TI exits the
zero procedure and all Zero indicators turn off. Then press Zero again to
begin the zero procedure. The Fail indicator will remain lit until you start
a new zero procedure.
If you continue to have an error, consult the chapter
Inclinometer
Level
Bracket
Beam
Holes (4)
Spoke
Adapters (2)
S10MC-17
Zero Button and
Indicators