MTS Criterion Series 60 - Manual (Page 83)

a) Use the actuator down button on the handset to lower the actuator. It moves slowly so you will need
to look closely to see if the upper crosshead and table are moving. When the actuator reaches the
bottom of its travel, the interlock will set.
b) Clear the interlock by pressing the handset enable button twice.
4. Raise the actuator slightly.
This helps ensure that the interlock does not inadvertently trip.
Set Up the Load Meter for Specimen Installation
1. If necessary, expand the meter area at the bottom of the window by clicking the small expand button
in the lower center of the window.
2. Change the load meter type to Running Maximum/Minimum.
MTS Criterion ™ Series 60 | 83
Running the Example Tension Test