MTS Landmark Tabletop - Manual (Page 29)

MTS Landmark Tabletop Load Units
Description Item
Axial 1
Axial-Torsional 2
Note: Load units are shown with optional grips, fixtures, and accessories. 3
What you need to know
MTS Systems Corporation assumes that you know how to use your controller. For information about performing
any controller-related step in this manual's procedure, see the appropriate manual. You are expected to know
how to perform the following procedures:
• Turn hydraulic pressure on and off.
• Select a control mode.
• Adjust the actuator position.
• Zero a sensor signal.
• Zero a sensor output.
• Use your grips and fixtures.
• Define a simple test.
• Run a test.
Related products
The Series 370 Tabletop Load Unit includes several other products. For product-specific information and
maintenance procedures, see the following product information manuals.
• The Series 111 Accumulator Product Information manual (MTS part number 011-553-304)
• The Series 252 Servovalve Product Information manual (MTS part number 011-182-906)
EU Declarations
The load units, controllers, and optional equipment are supplied with Product Information manuals that allow
them to be assembled and integrated to work as assemblies of machinery.
The customer must evaluate risks due to ejected parts or materials from the test specimens. If the test area
enclosure option is not selected by the customer, then for protection against ejected parts or materials from
test specimens and to control access to the machinery, the customer must provide a test area enclosure.
MTS Landmark™ Tabletop Load Units Product Information 29
Introduction