NTi Audio Digilyzer DL1 - Manual (Page 13)

13
Connectors
The Digilyzer includes the following connectors:
NOTES • For AES3, 75 Ohm, signals (BNC connector) use the
attached Chinch-BNC adapter.
• Insert a jack into the headphone output to switch
of the analog monitoring with the internal speaker
(e.g. during a live act).
Rubber Cushions
The original packaging of the Digilyzer includes a pair of rubber
cushions. These may be adhered on the rear side of the device, so the
output signal is made audible in good quality also whilst the Digilyzer
lays, e.g. on a table, with the speaker on the bottom side.
Chinch-BNC Adapter
The Chinch-BNC Adapter enables the measurement of the AES3id,
75 Ohm standard with the Digilyzer. AES3id is especially required
for the transmission of digital signals over longer cables with a cable
length >100 m.
Fig 2-09, Inputs and outputs of DL1
AES3, 110 Ohm
terminated
TOS-Link /
ADAT
Headphone
output
S/PDIF, 75 Ohm
terminated
Overview