NTi Audio Digilyzer DL1 - Manual (Page 16)

16
5. Decrease the volume
Press and hold the ESC- and
left cursor key simultaneously.
This causes the FAST
ACCESS SETUP screen to
be displayed and the volume
to decrease.
6. Measure the accuracy of the
sampling rate
The accuracy is measured
in ppm, so the unit of the
sampling frequency has to be
changed as follows:
- Move the cursor to the unit
“Hz”.
- Press the enter key to select.
- Press any cursor key to
change from “Hz” to “ppm”.
-> The measured accuracy is
immediately displayed.
- Press the enter key to confirm
the new setting.
7. A c t i v a t e t h e V U + P P M
function
- Press the ESC key twice
(cursor moves to the left
top!).
- Press the enter key to open
the measurement menu.
- Move the cursor down to
VU+PPM.
- Press the enter key to confirm
the new setting.
Decrease/increase
volume hot-keys
5. Volume
indication
6
7
Fig 3-03, Volume setting
Fig 3-04, PPM setting
Fig 3-05, VU+PPM mode
First Steps