MacDon R80 Rotary Disc - Manual (Page 16)

OPERATION
Form # 169089
14
Model Year - 2009
6.3 HEADER ATTACHMENT
Refer to the M150 & M200 Self-Propelled
Windrower Operator’s Manual for procedures for
mechanically attaching the disc header to the
self-propelled windrower. Refer to the following
procedures for electrical and hydraulic
connections. The header drive hydraulic hoses
and electrical harness are located on the left
cab-forward side of the tractor.
6.3.1 M200 – 13 FT & 16 FT
6.3.1.1 TRACTOR CONNECTIONS
a. Disengage and rotate lever (A) counter-
clockwise to fully up position.
b. Remove cap (B) securing electrical connector to
frame.
c. Move hose bundle (C) from tractor through hose
support (D) on header.
d. Route header return and pressure hose bundle
(E) through header support (D) to tractor, and
locate bundle above existing hose bundle (C) as
shown.
e. If grass seed header is being attached, route
converging drum hose bundle (F) through
header support (D) to tractor, and locate bundle
above existing hose bundles as shown.
f. Lower and lock lever (A).
g. Secure hose bundles with three cinch straps
(G).
h. Move tractor left side platform to open position.
i. Connect two hose bundle from header to middle
valve block as shown.
(continued next page)
A
C
B
D
C
E
F
D
G
A
RETURN
PRESSURE