MacDon R80 Rotary Disc - Manual (Page 65)

MAINTENANCE/SERVICE
Form # 169089
63
Model Year - 2009
g. Locate feed plate (D) on the disc ensuring that
hole in feed plate registers on disc. Position
plate approximately as shown and align holes.
IMPORTANT
Feed plate should be located so that when
holes are aligned, it is closer to the cutter
blade leading edge (E) than the trailing
edge.
h. Re-position deflector (C) and align holes.
i. Re-install bolts (B) and tighten to 92 ft·lbf (125
N·m).
j. Repeat above steps for opposite side.
k. Manually rotate discs to check for interference of
feed plate and adjacent parts.
B
C
D
E