MacDon 872 Combine Adapter - Manual (Page 31)

31
COMBINE MAKE & MODEL
REAR
DEFLECTORS
OPENING WIDTH
Case 60 & 66 Series 37” (940 mm)
Case 80 & 88 Series 43.7” (1110 mm)
John Deere 9600, 9610, 9650 * 60.2” (1530 mm)
JD CTS/STS, Contour Master,
9500 & 9510 *
54.9” (1395 mm)
New Holland TR & Gleaner 38.2” (970 mm)
New Holland TX * 54.9” (1395 mm)
Cat Lexion 450 & 470 Series 47.6” (1210 mm)
Cat Lexion 460 & 480 Series * 59” (1500 mm)
ASSEMBLY
INSTALL HEADER SIDE DRAPERS & SET DECK DEFLECTORS
1. Connect side drapers according to your Header Operator’s Manual or Set-Up Instructions.
IMPORTANT: Cut off any excess flap only after drapers have been connected and tensioned and overlap
at sides of feed draper deck has been checked.
2. For proper feeding in most crops, the header side draper idler rollers should be set to an opening of:
59.5” (1510 mm) for wide deck adapters: John Deere 9600/9610/9650 and Cat 460 & 480 Series
53.5” (1360 mm) for wide deck adapters: John Deere STS/CTS/9500/9510 and New Holland TX
49.6” (1260 mm) for mid-size deck adapters: Cat 450 & 470 Series
41.7” (1060 mm) for mid-size deck adapters: Case 80 & 88 Series
37.4” (950 mm) for narrow deck adapters on 972 Headers: Case 60 & 66 Series, Gleaner &
New Holland TR
33.9” (860 mm) for narrow deck adapters on 962 Headers: Case 60 & 66 Series, Gleaner &
New Holland TR
In some cases, actual opening size will be
varied by re-positioning deck on one side to
properly overlap and align with feed draper. See
plasticized Set-Up card provided.
NOTE: Side deflectors (A) and rear deflectors
(B) are factory set for an opening width to
correspond to the feeder house opening for a
specific model of combine, according to the
following chart.
The rear vertical edge of the deflectors (B)
should just fit inside feeder house opening. If
factory setting is not correct for your model of
combine, loosen two bolts (C) and adjust rear of
deflector to suit feeder house opening.
NARROW DECK ADAPTERS
A
B
C
MID-SIZE DECK ADAPTERS
A
B
C
WIDE DECK ADAPTERS
A
B
C
NOTE: For wide deck adapters (those with * above),
the rear deflector setting is dictated by the position of
the plastic closure panel. See page 34.