MacDon 872 Combine Adapter User Manual
Page 58
58
Adapter Mounting Instructions
for New Holland Combines
PREPARING THE ADAPTER
1. Install feeder house guide (1) (from adapter
package) onto the adapter frame with hardware
shown. Repeat at other side.
2. Install lower feeder house beam (2) with
hardware shown. Position bolts against the
bottom of the slots in frame.
3. Install lower latch eyebolt assemblies (3) in
adapter frame.
4. Attach gearbox support (4) to combine feeder
house as shown.
NOTE: Orientation of support depends on
combine model.
5. For TR Combines only, add float range limiters
to prevent damage to the retracting tine drum
and/or header side drapers when operating at
flat header angles. See instruction on page 71.
A
BOLT - flange head, 1/2 NC x 1 inch
B
NUT - smooth flange, 1/2 NC distorted thread
C
BOLT - round hd, square nk, 5/8 NC x 1-1/2"
D
NUT - lock, 5/8 NC distorted thread
E
WASHER - flat 21/32 inch I.D.
M
SETSCREW – 3/8 NC x 1 ¼ inch
N
NUT – hex jam, 3/8 NC
P
BOLT – flange head, 3/8 NC x 1 inch