MacDon 872 Combine Adapter - Manual (Page 9)

9
HEADER ATTACHING & DETACHING
ATTACHING HEADER TO COMBINE AND ADAPTER
(continued)
15. Install anchors to clamp feed pan to cutterbar
as shown.
16. Check for 0 to 5 mm (3/16 inch) clearance
between front of adapter feed pan and
cutterbar. Adjust clearance as follows:
a. Raise the header. Stop engine and remove
key.
DANGER: To avoid bodily injury
from fall of raised header, engage
header lift cylinder stops when
working on or around raised
header. See your Combine Operator’s Manual
for details.
b.
•
Loosen bolts (F) and (G).
•
Adjust feed pan clearance to cutterbar to 0 to
5 mm (3/16 inch).
•
Tighten bolts (F) and (G).
•
Remove all blocks, disengage header lift
cylinder stops and lower header to ground.
•
Ensure that outside anchors (E) are installed
as shown, with rubber seal (J) under top plate
of anchor.
SIDE VIEW
ADJUST FEED PAN - 962 HEADER
0 to 5mm
F
E J
G