MacDon 872 Combine Adapter - Manual (Page 54)

54
Adapter Mounting Instructions
for Gleaner Combines
ATTACHING ADAPTER TO COMBINE (continued)
5. Install pump as follows:
NOTE: Wear gloves when handling pump.
a. Remove pump from storage position (A) on
adapter and slide pump onto R/H feeder house
output shaft.
NOTE: The first time the pump is installed,
hoses may have to be loosened for proper
alignment. Tighten hoses after installation.
b. Engage pump torque arm on support arm on
adapter and secure with lynch pin at (B).
6. Float the feeder house front drum up and
check for interference with adapter feed drum.
If so, remove a link from the feeder chain and
move the front drum back. Re-tighten chain
and check clearance again.
PUMP STORAGE ON ADAPTER
A
PUMP IN WORKING POSITION