MacDon 872 Combine Adapter - Manual (Page 35)

35
DRILL TWO 11/32 HOLES
FOR HARNESS CLIPS AT
DIMENSIONS BELOW
HARNESS ENTERS
CHANNEL HERE
HARNESS EXITS CHANNEL HERE FOR
SENSORS AT CENTER OF HEADER
(HOLES MEASURED FROM OUTBOARD
EDGE OF THIS CUT-OUT)
HARNESS EXITS CHANNEL
HERE FOR SENSORS AT R/H
END OF HEADER
ASSEMBLY
ELECTRICAL HARNESS
Attach electrical harness extension, (shipped with adapter) to your header wiring harness. This allows
connection to combine harness for operation of amber lights on header.
NOTE: For combines that do not have a harness connector for feeder house attachments, order Wiring
Harness (MacDon Part No. 40435), and splice into combine harness as follows:
Dark Blue Wire: to L/H turn signal circuit
Light Blue Wire: to R/H turn signal circuit
Black Wire: to Ground
NOTE: If combine will be used with Hydraulic Deck Shift Header for end delivery windrowing, order B-2407
Harness and Support for deck shift switch. Installation instructions are included with the package. The deck
shift switch is supplied with the Hydraulic Deck Shift Header.
NOTE: Some combine adapter wiring harnesses are supplied with circuits for special functions such as:
•
Reel Speed Sensor
•
Reel Height Sensor
•
Header Height Sensor
The routing of these harnesses for 962 and 972 Headers is described on the Installation Instructions
provided with the sensor kits. For 972 headers, holes for harness clips are not provided in some headers.
For these headers, drill two 0.343” (11/32”) holes as shown below:
CUT-OUT IN CHANNEL UNDER
HEADER FRAME TUBE
280 mm
(11”)
580 mm
(22.8”)
70 mm
(2 ¾”)