RKI Instruments Pioneer 16R - Manual (Page 19)

- To accept the instrument label setting and continue the program, press the ENTER button until
the Instrument Setup Exit screen displays.
- To update the instrument label setting:
1.
Use the ENTER button to select the character you want to change. (The character flashes
when it is selected.)
2. Press the UP/YES or DOWN/NO button to display the character you want, then press the
ENTER button to select the next character.
3. Repeat steps 1 and 2 until the label is correct, then press the ENTER button until the
Instrument Setup Exit screen displays.
• Instrument setup exit screen
This screen saves or cancels any changes you made in the Instrument Setup program.
- To save changes and exit the program, press the ENTER button. A confirmation message
displays, then the normal screen displays. The Pioneer is in normal operation.
- To cancel changes and exit the program, press the ESCAPE button until the following message
displays: “INSTRUMENT SET-UP NOT SAVED. USING PREVIOUS VALUES.” Then the normal
screen displays and the Pioneer is in normal operation.
Display Setpoints and Readings Program
This section describes the Display Setpoints and Readings program. You can display the following in this
program. (You can also allow the Pioneer to perform a self check procedure and reset the minimum and
maximum readings in this program.)
•
Software versions
• Time Weighted Average (TWA) and Short Term Exposure Limit (STEL) readings (for applicable
channels)
• Minimum and maximum readings (for each channel)
• Alarm Sets (for each channel)
Navigating Through the Display Setpoints and Readings Program
Use the reset switch to begin the program, display the setpoints and readings, and exit the program.
N O T E : This is a display only program. You cannot change settings or gas readings in the Display
Setpoints and Readings program.
Running the Display Setpoints and Readings Program
This section describes how to display the various setpoints and gas readings that are included in this
program. This section also describes how to display the time and date and begin the self check
procedure.
N O T E : Once you display one of the screens, the Pioneer automatically returns to the normal screen in
1 minute if you do not continue or exit the program.
• To display software versions:
The Display Setpoints and Readings program displays the version number of the Pioneer’s
Pioneer-R16 Operator’s Manual Operation 18