Robustel R3000 NU - Manual (Page 36)

Robustel GoRugged R3000 NU User Guide
RT_UG_R3000 NU_v.1.0.0 24.03.2014 35 / 110
Confidential
R3000 NU connects to.
Mode Show current mode of R3000 NU: AP or Client. Null
Key Management
Show current security mode of R3000 NU or the access point which
R3000 NU connects to.
Null
Cipher Pairwise Show current encryption algorithm of R3000 NU or the access point
which R3000 NU connects to.
Null
Cipher Group
WPA State
Show current WPA status. Mainly there are 5 statuses: Disconnected,
Scanning, Initializing, Associated, 4way_handshark, Completed.
Disconnected: Not associated or connected with any access point,
perhaps because the wireless device has not fully initialized, is out of
range, or the wireless interface is disconnected because the Ethernet
interface is enabled.
Scanning: Searching for a wireless network (access point) for
connection.
Initializing: R3000 NU is setting up initial wireless environment.
Associated: This state is entered when the driver reports that
association has been successfully completed with an AP, but still waiting
for authentication.
4way_handshark: This state is entered when WPA/WPA2 4-Way
Handshake is started. When Passphrase do not match, it will show this
status.
Completed: The wireless connection of R3000 NU and other wireless
devices are established.
Null
Address Show the MAC address of R3000 NU’s WiFi interface. Null
Associated Clients @ AP
mode
Show current associated wireless client devices’ BSSID and IP address. Null
Scan Results @ Client
mode
Show current scan results of any wireless network (access point), such
as SSID, Channel, Signal Level, Flags (the security mode and encryption
algorithm flags of access point).
Null
3.13 Configuration -> Serial
This section allows users to set the serial (RS232/RS485) parameters.