Schwank compactSchwank P40-R - Manual (Page 11)

11
P40R-F I&O Manual
IM120801
RD: MAY 2014
RL: 3A
1. APPLICATION
Model P40-R has been design certified to ANSI Z21.86 / CSA 2.32 Vented Gas-Fired Space
Heating Appliances (Vented Overhead Heater).
Model P40-R may be installed for heating of an indoor residential garage, workshop, or green-
house. This heater can also be installed in light commercial/industrial locations.
This heater must not be installed in any dwelling area of a residence, nor in a basement, mo-
bile home, or recreational vehicle.
This heater is not for installation in a Class 1 or Class 2 explosive environment. If the application
is in question, consult with local authorities having jurisdiction (Fire Marshall, inspection depart-
ment, insurance underwriter, or other authority having jurisdiction).
 Due to high temperatures, the appliance should be lo-
cated out of traffic and away from furniture and draperies.
 Children and adults should be alerted to the hazards of
high surface temperatures and should stay away to avoid
burns or clothing ignition
 Young children should be carefully supervised when they are in the
same room as the appliance
 Clothing or other flammable material should not be placed on or
near the appliance
 Any safety screen or guard removed to service an appliance must be
replaced prior to operating the appliance
 Installation and repair should be done by a qualified service person.
The appliance should be inspected before use and at least annually
by a qualified service person. More frequent cleaning may be re-
quired due to excessive dust or contaminants from activities in the
area of the appliance. It is imperative that control compartments,
burners and air passageways of the appliance be kept clean.
It is beyond the scope of these instructions to consider all conditions that may be encountered.
Installation must conform with local building codes or, in the absence of local codes, with the Na-
tional Fuel Gas Code, ANSI Z223.1/NFPA 54 in the U.S.A. or the Natural Gas and Propane In-
stallation Code, CSA B149.1 in Canada. The latest edition Electrical Code ANSI/NFPA N0 70 in
the U.S.A. and PART 1 CSA C22.1 in Canada must also be observed.
Installation of this heater must conform to all heating installation procedures in this manual in-
cluding suspension, maintenance of clearance to combustibles, connection to the gas and electri-
cal supplies, and ventilation.
Revisions to codes and/or standards, may require revision to equipment and installation proce-
dures. In case of discrepancy, the latest codes, standards, and installation manual will take prior-
ity over prior releases.