Schwank ThermoControl Plus Series CM-485 - Manual (Page 15)

- 15 -
ThermoControl-Plus 4
*0000h: Hi: Controller type code (37h),
Lo: Version number.
0002h: No function
0004h: Disable or enable buttons individually. Detailed in Appendix.
0006h: Simulation of pushing a button . Detailed in Appendix
0008h: Special button combinations. Detailed in Appendix
000Ah: Simulation of releasing a button.
000Ch: in Zone 1 control is enabled (On) or disabled (Off), 1: On, 0: Off
000Eh: in Zone 2 control is enabled (On) or disabled (Off), 1: On, 0: Off
0010h: in Zone 3 control is enabled (On) or disabled (Off), 1: On, 0: Off
0012h: in Zone 4 control is enabled (On) or disabled (Off), 1: On, 0: Off
0014h: in Zone 5 control is enabled (On) or disabled (Off), 1: On, 0: Off
0016h: in Zone 6 control is enabled (On) or disabled (Off), 1: On, 0: Off
0018h: in Zone 7 control is enabled (On) or disabled (Off), 1: On, 0: Off
001Ah: in Zone 8 control is enabled (On) or disabled (Off), 1: On, 0: Off
001Ch: Set value type selection in Zone 1:
0000h: Based on time program,
0001h: Frost protection value (continuously)
0002h: Night value (continuously)
0003h: Day value (continuously)
001Eh: Set value type selection in Zone 2: same as described at Zone 1
0020h: Set value type selection in Zone 3: same as described at Zone 1
0022h: Set value type selection in Zone 4: same as described at Zone 1
0024h: Set value type selection in Zone 5: same as described at Zone 1
0026h: Set value type selection in Zone 6: same as described at Zone 1
0028h: Set value type selection in Zone 7: same as described at Zone 1
002Ah: Set value type selection in Zone 8: same as described at Zone 1
002Ch: Zone1 Day set value ×10 with plus/minus sign.
Example: 00C7h 19.9°C
002Eh: Zone2 Day set value ×10 with plus/minus sign
0030h: Zone3 Day set value ×10 with plus/minus sign
0032h: Zone4 Day set value ×10 with plus/minus sign
0034h: Zone5 Day set value ×10 with plus/minus sign
0036h: Zone6 Day set value ×10 with plus/minus sign
0038h: Zone7 Day set value ×10 with plus/minus sign
003Ah: Zone8 Day set value ×10 with plus/minus sign
003Ch: Zone1 Night set value ×10 with plus/minus sign
003Eh: Zone2 Night set value ×10 with plus/minus sign
0040h: Zone3 Night set value ×10 with plus/minus sign
0042h: Zone4 Night set value ×10 with plus/minus sign
0044h: Zone5 Night set value ×10 with plus/minus sign
0046h: Zone6 Night set value ×10 with plus/minus sign
0048h: Zone7 Night set value ×10 with plus/minus sign
004Ah: Zone8 Night set value ×10 with plus/minus sign
004Ch: Zone1 Frost protection value ×10 with sign. This value acts as a low limit for all
of the other set values. Factory settings: 0050h 8.0°C
004Eh: Zone2 Frost protection value ×10 with sign
0050h: Zone3 Frost protection value ×10 with sign
The *-marked addresses are “Read-only” types