Sulky RS 350 - 1000 - Manual (Page 44)

RS Centrifugal Spreader.................................................................................................................................................... Page 42
(Safety at work continued)
- The spreader must only be put into service if all the safety devices are ins-
talled correctly. The spreader warning notices must be replaced if they are
missing or illegible.
- Before starting spreading, everyone must leave the spreader projection
area. The projected spreading products constitute a hazard!
- Never leave the spreader in operation without surveillance.
- Carrying people on the spreader during transport and use is prohibited.
- Comply with the weight-on-wheels for the front wheels of the towing vehi-
cle. Behaviour when being driven, as well as turning and braking capacity,
is influenced by the coupled equipment. Therefore ensure there is suffi-
cient vehicle turning and braking capacity. Also comply with the authori-
sed load per axle and total weight of the vehicle. Adapt your driving to
weather conditions and the modified dynamics.
- If there is damage, the spreader must be stopped immediately. Remove
the ignition key from the vehicle and repair the damage before the sprea-
ding equipment is used again. The same goes for damage to the universal
joint.
- A non-compliant selection or use of spreading products may cause se-
rious bodily harm as well as harm to animals, plants and the environment.
So read the manufacturer’s instructions and those for spreading products
and select the correct product for the intended use.
3.3.Safety when work has finished
- Before leaving the vehicle, the spreader must be placed on the ground,
the engine turned off and the ignition key removed.
- If the spreader is uncoupled, the reservoir must be empty and the storage
surface must be flat and stable.
Safety